Introduction
This package provides generic remote peek and poke operations for 16-bit and 32-bit entities.
Word Order: For either Short (n = 16) or Long (n = 32), an n-bit number on the source machine is mapped to (the same) n-bit number in standard representation on the wire, which is mapped to (the same) n-bit number on the target machine.
Types
Short: TYPE = CARDINAL;
Long: TYPE = LONG CARDINAL;
SeqShort: TYPE = SEQUENCE OF Short;
Address: TYPE = LONG CARDINAL;
OpCode: TYPE = { peekShort(0), pokeShort(1) };
PeekShortCmd: TYPE = RECORD [address: Address];
PokeShortCmd: TYPE = RECORD [address: Address, value: Short];
Cmd:
TYPE =
CHOICE OpCode
OF {
peekShort => PeekShortCmd,
pokeShort => PokeShortCmd };
SeqCmd: TYPE = SEQUENCE OF Cmd;
PeekShortResult: TYPE = RECORD [value: Short];
PokeShortResult: TYPE = RECORD [];
Result:
TYPE =
CHOICE OpCode
OF {
peekShort => PeekShortResult,
pokeShort => PokeShortResult };
SeqResult: TYPE = SEQUENCE OF Result;
Errors
Fault: ERROR [code: FaultCode, address: Address] = 0;
FaultCode:
TYPE = {
nonexistent(1), -- the referenced memory location does not exist
protection(2), -- access denied (can't happen with Softcard?)
alignmentShort(3), -- alignment error for Short (can't happen with 6085)
alignmentLong(4) -- alignment error for Long
};
Procedures
Procedure 0 is reserved for address lookup - not used at the moment
PeekShort:
PROCEDURE [address: Address]
RETURNS [result: Short]
REPORTS [Fault]
= 1;
PokeShort:
PROCEDURE [address: Address, value: Short]
REPORTS [Fault]
= 2;
PeekSeqShort:
PROCEDURE [address: Address, count:
CARDINAL]
RETURNS [resultSeq: SeqShort]
REPORTS [Fault]
= 3;
PokeSeqShort:
PROCEDURE [address: Address, valueSeq: SeqShort]
REPORTS [Fault]
= 4;
PeekLong:
PROCEDURE [address: Address]
RETURNS [result: Long]
REPORTS [Fault]
= 5;
PokeLong:
PROCEDURE [address: Address, value: Long]
REPORTS [Fault]
= 6;
DoCmds:
PROCEDURE [cmdSeq: SeqCmd]
RETURNS [resultSeq: SeqResult]
REPORTS [Fault]
= 7;