Writing a New 10SYS TapeMaxc Operations6817. WRITING A NEW 10SYS TAPEMaxc1 only. If any system files have been changed, they should exist on the Nova disk prior tobeginning the following procedure. It is assumed that all the normal system files are on the disk (ifnot, load them from the current 10SYS tape first).A.Clean up the disk as much as possible by deleting scratch files and other extraneous junk.B.Mount the new 10SYS tape on unit 0, with a write ring in it. (You must use magtape unit 0for 10SYS tapes since DOS will not handle any other drive.)C.Type:XFER TBOOT.SV MT0:0; XFER MAXCSYS.SY MT0:1 DUMP/A/V MT0:2 D.Check that everything is written ok by typing:LOAD/A/V MT0:2 "File already exists" should be printed for every file.E.Remove write ring. Label tape jacket as follows:0 TBOOT.SV1 MAXCSYS.SY2 *.* ...Current 10SYSF.Change the label on the old 10SYS tape to read "Obsolete 10SYS ".џю)яfЊqєXю;ђpєi ю Зюя_ЃrєXю Зя\1sєЄ t№:єЅю ЗяZfє†№Yє‡ ю ЗяXœє€№2ю ЗяU*ю2єX№Zю ЗяQИю2єš№5є›№%ю ЗяOэє€№;ю ЗяL{ю2юияI єX№/юияG?ю ЗяCЭю2№.юия@[ю Зя<щ№7ю Зя9wю2№1юия6 юия4: юия2pюия0Ѕ юия.кюия- юия+E ю Зя'гю2№OР З'Œ=ч@‹ TIMESROMAN  TIMESROMAN  TIMESROMAN  TIMESROMAN  TIMESROMAN uџџj/–Jн{џџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџџMaxcOps17.bravoRWeaverNovember 25, 1980 1:32 PM