Maxc OperationsStarting Tenex136. STARTING TENEXThe current Micro-Exec normally has been setup to have the current disk configuration. If youdoubt this, type:Print.Disk.Configuration (P D C)and it will print out the current disk configuration. Compare this to the numbers on the mounteddisk packs. If you are confident, type:GOwhich will first run a brief (~30 second) memory test, then boot in Tenex from the disk and start itrunning.If the disk configuration printed does not agree with the actual then type:Set.Disk.Configuration (S D C)which asks for parameters via the same format used in print.disk.configuration.After setting the correct disk configuration you must write MicroExec to area 1 by typing:Write.Micro.Exec.To.Area 1(W M E T A.1)Now you may type:GOTenex may ask for the date and time. (The prompt specifies the format.) Please be careful to enterthis correctly. If Tenex asks you to reconfirm your typein, you probably blew it and you should hit"Del" and try again. (But if you are really sure you typed the correct date and time, confirm withcarriage return).Tenex then runs the Bsys and Checkdsk programs to verify the consistency of the file system. Thistakes about 15 minutes (the time is proportional to the number of files in the entire system), at theend of which is broadcast the message "Tenex in operation" if all is well. If any uncorrectableerrors have been detected, the message "Tenex not available: Disk needs fixing" will be broadcast.If this occurs, you should attempt to notify system personnel. As a last resort, consult Section 18for information on fixing errors of this sort.If Tenex was last taken down in an orderly fashion (as opposed to crashing), it is not reallynecessary to run Bsys and Checkdsk (though it will never hurt to do so). The running of theseprograms may be bypassed (saving 15 minutes) by the following procedure:1.Load the microcode using the MEXECGO command file, as described at the end of theprevious section. This causes Micro-Exec to be started on Maxc. fpi' ,4 O 31 /. O 8& (H 2Q @ >Zg TIMESROMAN  TIMESROMAN  TIMESROMAN  TIMESROMAN %j/ }ѪMaxcOps6.BravoRWeaverJuly 16, 1981 10:28 AM