CPBoardCheckout.doc	JDD	25-Jan-85 17:28:01


To check out the CP board you must run Dawn.          

    In the HistoryBuffer window,type 'Error' into Target:
    Type 'Dawn' into File:
    Select LoadArmGo!
 
    You will get a type-out that is basically the following.
    
    
        Load, Arm, and Go ...
	Loading CP from Dawn.fb.
	It took 1802 ms to load 1216 instructions. (32390 bits/sec)
	Loading CP symbols from Dawn.st.
	It took 1099 ms to load 414 tags, 20 R, 17 RH, and 4 U Reg symbols.
	Arming History Buffer to trigger at Error = .CR 40F, ok
	
	
	Triggered ...
           90     0  01101010  6A D c2  Trap ←←←← c3 expected
	   91     0  01101001  69 D c3  Trap
	   92   14F  01101100  6C D c1  Trap+1
	   93   429  01101010  6A D c2  Trap+2
	   94   135  01101001  69 D c3  Init
	   95   42A  01101100  6C D c1  NotCSPar
	   96   42B  01101010  6A D c2  NotCSPar+1
	   97   42C  01101001  69 D c3  NotCSPar+2
	   98   42D  01101100  6C D c1  NotCSPar+3
	   99   261  01101010  6A D c2  BadTrapB
	* 100   40F  01101001  69 D c3  Error
 	  101   41D  01101100  6C D c1  ErrorAgain
 	  102   420  01101010  6A D c2  ErrorAgain+1
 	  103   41F  01101001  69 D c3  Go
	  104    FF  01101100  6C D c1  bt1
	  105   F00  01101010  6A D c2  bt2
	  106   AA0  01101001  69 D c3  bt3
	  107    AA  01101100  6C D c1  bt3+1
	  108    AE  01101010  6A D c2  bt3+2
	  109    1F  01101001  69 D c3  C2Good0x
	  110    F0  01101100  6C D c1  C2Good0x+1
	  
	  
   After this type-out is complete Select Arm!
   You will get the following type-out.
	
	
	 Arming History Buffer to trigger at Error = .CR 40F, ok
	
	
   The maintenance panel on the dicentra should be 
   counting up if every thing is running ok.