//Icarus to Reticle of #1?Icarus" File:# to #2?Output" File(no" extension):# #3?Hundredths" microns" per" Icarus" units" (2" numbers):# #4?per:#
// This version is a big kludge -
// The magic code is set up to generate all layer files in one pass.
// However PressOut can't handle more than one Press file at a time, even though it's supposed to.  Problems are insufficient state held in PressFileDescriptor, and use of a single buffer file EntityList$.
// If PressOut ever gets fixed then all the vis~invis stuff below can be removed and Magic will generate all Reticle files in one pass, instead of the one pass per layer used here.
// i.e. the command should be:
//JaM magic (#1) #3 #4 readic outline reticle (#2)output .quit
JaM magic (#1) #3 #4 readic outline reticle ^
(NI)invis (ND)invis (NP)invis (NC)invis (NM)invis (NB)invis (NG)invis ^
(NI)vis (#2)output (NI)invis ^
(ND)vis (#2)output (ND)invis ^
(NP)vis (#2)output (NP)invis ^
(NC)vis (#2)output (NC)invis ^
(NM)vis (#2)output (NM)invis ^
(NB)vis (#2)output (NB)invis ^
(NG)vis (#2)output (NG)invis ^
.quit