Date: 17 Dec. 1982 7:19 pm PST (Friday)
Sender: Levin.PA
Subject: Cedar 3.5.2 release
From: Release Master
To: CedarUsers↑, CedarImplementors↑
cc: CedarCoordinators↑
Reply-To: Levin

Cedar 3.5.2 is released.

This is a "quick fix" release to eliminate the problem with Rollback noted in the
release message for Cedar 3.5.1.  Nothing else has changed. 

Installation Procedure
---------------------

This procedure assumes you have a machine with Cedar 3.5 or 3.5.1 installed. 
(Note to those who picked up Cedar 3.5.2 boot files dated 16 December:  you
should follow this procedure too.  Don't attempt any shortcuts.  The boot files
have been rebuilt.)  Otherwise, refer to the "Setting Up Your Disk" section of

     [Indigo]<Cedar>Documentation>Introduction.press

for further information.  (Be sure you have the version corresponding to this
release.)

  1)  Get to Othello.

  2)  [Optional] Erase your Client volume by typing Erase<CR> to Othello.  You
      will be prompted for the volume name, type Client<CR>.  Confirm as
      necessary.

  3)  Type @<CR> to Othello.  You will be prompted for a command file
      name.  Type either
	[Indigo]<Cedar>Top>DoradoRelease.cm          or
	[Indigo]<Cedar>Top>D0Release.cm
      as appropriate.  New boot files will be fetched for all volumes, as well as
      new microcode and germ files.

  4)  On Dorados, Cedar will automatically be booted upon completion of the
      command file.  (Actually, the CoPilot volume will first be booted, after
      then a physical volume boot will occur, causing Cedar to be booted.  Be
      patient.)  On Dolphins, the Alto partition will be booted; hold down
      the "P" key and press the boot button to boot Cedar.

  5)  During the installation dialogue, you may be asked if you wish to use a
      personal DF file.  You may safely answer "yes" to this question.



The Release Master