// DicentraSwitches.doc, HGM, 29-Dec-83 23:38:27

Misc Board:
	All open/off except 3.
	
ControlStore/Debugger board:
	Left switch: Close/on 3, 4, 5, 6, and 7.
	Right switch: All open/off.

SUN 3MB board:
	S507: Host number - 1 is LSB, 8 is MSB, open/off => 1.
	S505: Device address - All open/off except 7.
		Close/on 1 on second board, 2 on third board, 1+2 on 4th board....
		(Software currently has a limit of 6 boards.)

3Com 10MB board:
	ADR17/ (P2 end) all open/off.
	ADR13/ (P1 end) 6+7 closed/on.
		4 on second board, 3 on third board, 3+4 on 4th board....
		(Software currently has a limit of 6 boards.)
	Jumpers: INT2, IOWC, IORC, 20ADDR
		(park the 24ADDR jumper on one of it's pins)

Memory boards:
	All open/off for the first board.
	4 on (rightmost) for a second board.
	3 on for a third board.  3 and 4 on for a 4th board.
	The emulator only supports 2 boards.
	MemTest will play with more than 2, but don't forget to change highBank.

If you are using a second memory board, the CP, Misc, and Mem boards all need P2 connectors on the backplane.

Neither the 10MB Ethernet board nor the 3MB Ethernet board need a P2 connector.