DIRECTORY CD, DABasics, DesignRules, Route; NewRouteTechnology: CEDAR DEFINITIONS = BEGIN ContactSize: PROC [contact: CD.Object] RETURNS [CD.Number]; GetMaterialToContact: PROC [rules: DesignRules.Rules, layer: CD.Layer, contact: CD.Object] RETURNS [CD.Number]; LToTech: PROC [layer: CD.Layer] RETURNS [tech: CD.Technology]; GetContact: PROC [layer1, layer2: CD.Layer] RETURNS [CD.Object]; GetBigContact: PROC [size: DABasics.Position, layer1, layer2: CD.Layer] RETURNS [CD.Object]; CmosDesignRules: PROC [rules: DesignRules.Rules, designRuleParms: Route.DesignRulesParameters] RETURNS[designRules: Route.DesignRules]; DesignRulesParameters: PROC [rules: DesignRules.Rules, horizLayer, vertLayer: CD.Layer, trunkDirection: DABasics.Direction] RETURNS[designRuleParms: Route.DesignRulesParameters]; END. bNewRouteTechnology.mesa Copyright Ó 1985, 1987 by Xerox Corporation. All rights reserved. by Bryan Preas July 10, 1985 6:57:00 pm PDT last edited by Bryan Preas July 16, 1987 11:24:11 am PDT --This module is used to hide the actual technology used from quite technology --independent routing software. Not all technologies do support this module. Widths and Spacings Layers copied from CDSimpleRules Contacts -- Create a contact of minimal size; may return the same object -- on multiple calls; the contact object should be considered -- to be read-only. -- Create a big contact; may return the same object -- on multiple calls; the contact object should be considered -- to be read-only. Simple Design Rules Define the routing design rules for CMOS double or single layer metal. Define the routing design rules for CMOS double or single layer metal. Ê›˜Jšœ™˜JšœB™BJšœ*Ïkœ™.Jšœ:™:—J˜š ˜ Jšœ˜!J˜—šÐbnœœœ˜'Jš˜J˜JšÏcN™NJšŸM™M—headšÏb™codešÏnœœœ ˜;L˜—Lš¡œœAœ ˜o—š ™J˜š¡œœœœ ˜>Lšœ™——š ™J˜š¡ œœœ ˜@LšŸ?™?LšŸ=™=LšŸ™L˜—š¡ œœ5œ ˜\LšŸ3™3LšŸ=™=LšŸ™——šœ™J™—š¡œœJœ!˜‡šœ$œ™FL˜——š¡œœ3œ,œ/˜²šœF™FL˜—Lšœ˜—J˜—…—0-